E-I
Seal and Groove Dimensions in Millimeters (mm) |
|||||||||
Seal Height |
Seal Width |
Seal Diameter Range |
Sheet Thickness |
Seal & Groove Clearance |
Groove Height |
Groove Corner Radius |
Groove Width |
Spring Back Values (mm) |
Load Values N/mm circumference |
SH |
SW |
SD |
ST |
SGS |
GH |
GR |
GW |
SB |
LO |
L |
|||||||||
01.88 (+/-0.08) |
1.68 |
45 – 200 |
0.127 |
0.076 |
1.55-1.60 |
0.38 |
2.30 |
0.30 |
6 |
02.59 (+/-0.08) |
2.31 |
50 – 300 |
0.25 |
0.076 |
2.15-2.21 |
0.50 |
2.95 |
0.38 |
6 |
02.74(+/-0.08) |
3.68 |
60 - 300 |
0.25 |
0.076 |
2.15-2.25 |
0.50 |
4.35 |
0.53 |
7 |
02.74(+/-0.10) |
2.31 |
50 - 300 |
0.25 |
0.076 |
2.15-2.25 |
0.50 |
2.95 |
0.46 |
16 |
03.56 (+/-0.10) |
3.10 |
50 - 600 |
0.30 |
0.130 |
2.95-3.05 |
0.75 |
4.20 |
0.56 |
11 |
03.35 (+/-0.10) |
3.10 |
50 - 600 |
0.38 |
0.130 |
2.95-3.05 |
0.75 |
4.20 |
0.36 |
13 |
05.54 (+/-0.13) |
4.83 |
85 - 900 |
0.38 |
0.15 |
4.55-4.65 |
1.00 |
5.85 |
0.94 |
9 |
07.49 (+/-0.13) |
6.78 |
150 - 1200 |
0.51 |
0.20 |
6.20-6.35 |
1.50 |
8.00 |
1.22 |
14 |
Note: Above given values are based on lab setup conditions especially the Load and Spring-Back values. Practically the values can differ based on the actual seal size, groove conditions, groove dimensions, surface finish and seal plating conditions.